Genmega G2500 series Operator's Manual page 99

Part B is entered with the same procedure given for Part A. Enter the left and right (for TDES)
portions of the keys and verify the check digits against what has been provided by the processor.
3) Verifying Master Key
At this point, the master key is successfully entered. If all other parameters have been entered
properly, power off the ATM and power on to connect to host and initialize the keys.
Master Key Installation
After successfully entering both the left and right
portions of Part A, you'll be returned to the Edit
Master Key menu.
At this point you can proceed with Part B, or if Part
B is to be entered at a later time you can exit the
menu and power off the machine until both halves
of the key are entered.
Once both Part A and Part B have been entered
successfully, the key management menu will
display a check digit for the key index where the
master key was entered. If no check digit is
entered, use the check key screen to determine
where the key parts were entered, then re-enter
the keys as necessary.
C.7
Operator Manual
© Genmega 2012