Advertisement
Quick Links
Advertisement
Related Manuals for Genmega GT5000
Summary of Contents for Genmega GT5000
- Page 1 Installation Specs © 2018 Genmega www.genmega.com...
- Page 2 This machine uses a standard 3-prong 115V AC power cord. For warranty purposes, Genmega requires the GT5000 ATM should be connected to a dedicated power circuit (5amp minimum). This circuit must consist of line, neutral, and ground leads connected directly to the circuit breaker panel.
- Page 3 Construction Dimensions: The wall hole should be sized 35.7” (height) and 20.5” (width) as shown below. The maximum wall thickness for installation is 10”. If a wall thickness of less than 4” will be used, then you will need to fabricate a spacer to fill the distance between the back of the wall and the side brackets.
- Page 4 Setting the height of the hole: The ADA guidelines require unobstructed front and side access – as well as a maximum ‘control’ (button) height of 48” – this means that the uppermost buttons on the sides of the screen must measure no more than 48”...
- Page 5 The following shows the maximum height to set the hole so that the machine is at the maximum allowed height for ADA compliance.
- Page 6 The outside dimensions of the GT5000 are shown below, the 24” X 38.5” dimension represents the machine with the front bezel installed. See end of this manual for instructions on removing the bezel.
- Page 7 Below shows how much distance is required to open the rear door and for possibly servicing the cash dispenser. It’s 34” from the backside of the outer bezel to the back of the T-handle on the vault. From the front of the vault - you’ll need 37” of rear clearance to fully open the vault door and 49” to fully extend the sliding tray where the cash dispenser is mounted.
- Page 8 Bezel Removal To remove the outside (gray) perimeter bezel from the front of the machine during installation, please reference the image below. Inside the top cabinet are two metal brackets that secure the front bezel. Undo the thumbscrews and pull back the metal tabs.