Genmega G2500 series Operator's Manual page 91

ERROR ERROR DESCRIPTION
CODES
F000A Master Key is empty.
F000B Host Telephone Number is not
set.
F000C Error Retry timer is not set.
F000D RMS Password is not set
when RMS is enabled.
F000E RMS phone number is not set
when RMS send is enabled.
F000F Terminal ID is not set.
F0010 Routing ID is not set.
F0011 Master Key Serial number is
not set
F0013/ NVRAM Failure
14
F0015 Serial Number not Set
F0016 Master Password left at
default
Error Codes
CORRECTIVE ACTION
Check Master Key checksum – reinject key (Host Setup)
Set Host Telephone Number – (Host Setup)
Set Error retry time (Host Setup)
Set RMS Password – (Host Setup)
Set RMS Phone number – (Host Setup)
Set Terminal ID number – (Host Setup)
Set Routing ID number – (Host Setup)
Set Master Key serial number – (Host Setup)
Fatal error, defective memory chip. Replace Mainboard.
Set Serial number in Operator Menu
ATM will not go into service with the default master password. The
master password must be changed from default.
A.6
Operator Manual
© Genmega 2012