Customer Transactions; Opening Procedure - Genmega G2500 series Operator's Manual

CUSTOMER TRANSACTIONS

6.1 OPENING PROCEDURES
This section explains how to place your ATM in service.
Step 1
Open the front panel and turn the power on. (see page 4.3)
Step 2
If there is no receipt paper, load the receipt paper. (see page 4.15)
Step 3
Open the security door and replenish the cash cassette. (see page 4.1)
Step 4
Go into the OPERATOR FUNCTION mode and input the number of bills in the cash cassette.
(See page 4.17)
Step 5
Exit the OPERATOR FUNCTION MODE.
Step 6
After connecting to the processor, the terminal will be ready for service.
Step 7
If the machine is not ready for service, please check the following:
- Read the error message on the screen and follow any instructions.
- Determine if the phone line is working or internet connection is properly set up.
- Determine if all Host Setup parameters are correct;
- If, after doing the above steps, the ATM is still not in service, contact your service
personnel. Make sure to note any error codes that appear on the screen.
Customer Transactions 6.1
Operator Manual
© Genmega 2011