Surcharge Mode - Genmega G2500 series Operator's Manual

Operator Manual

3.4.5 SURCHARGE MODE

The Surcharge menu displays the current rate at which customers are charged per transaction,
the person or account that the surcharge funds are sent to and whether or not the option to
surcharge is enabled or disabled. The information programmed here must match the information
given to the processor at the time the account was created. Because of features like Percentage
Surcharge that require the surcharge value to be set at the ATM, it's possible for the ATM to
override what the processor expects to surcharge (or not surcharge customers at all) if these
settings are not correct.
Please review the following setting carefully and instruct your operators on the risks involved in
changing surcharge settings.
To set the surcharge parameters begin by entering the Surcharge Mode menu from the Customer
Setup menu. The bottom of the screen displays the current status of each surcharge parameter.
DISABLE/ENABLE
This button toggles the surcharge option on and off.
AMOUNT
To set the surcharge amount, press the amount button and type the dollar amount using the main
keypad. Next set the decimal point using the Enter key on the keypad. Then type the cents
using the keypad and finally press Enter to finish.
Programming 3.28 © Genmega 2011