Programming; Initial Setup; Accessing The Operator Function Menu - Genmega G2500 series Operator's Manual

PROGRAMMING

3.1 INITIAL SETUP

3.1.1 ACCESSING THE OPERATOR FUNCTION
To access the Operator Menu, press these keys in order [ENTER] – [CLEAR] – [CANCEL] – [1] –
[2] – [3].
Note: The Operator Function menu can only be accessed when the machine is either in service
("insert your card" screen) or out of service. If the machine is attempting to connect to the host or
initializing, you will not be able to use the key commands to access the Operator Function Menu.
If you have difficulty accessing the Operator Menu, power off the ATM and then either open the
vault door or remove the cassette from the dispenser and then power back on. This will force the
ATM to the Operator Menu. (See Step 1 on 3.3)
WARNING: Genmega highly recommends changing your passwords from default as soon as
possible. Keep all passwords safe and restrict access to non-authorized personnel.
Passwords MUST be 6 digits in length, use of anything other than a 6 digit password may cause
the passwords to revert back to factory default.
Programming
Once you successfully completed the key
combination, you will be prompted to enter a
password. There are 3 levels of passwords.
•
Operator Password (allows access to basic
menu structure)
•
Service Password (allows access to basic and
diagnostic menus)
•
Master Password (allows access to all menus
including setup parameters)
You must press ENTER key after typing the
password!
Passwords are very important to maintaining
security for your ATM. Your dealer/distributor will
provide you with default password information.
3.1
Operator Manual
© Genmega 2011