Genmega G2500 series Operator's Manual page 27

Operator Manual
To enable the RMS Schedule options, you must first enable RMS Send, and input the phone
number or IP address of your RMS PC. Remember that for Internet communications you MUST
have a publicly addressable IP address for your RMS computer so the ATMs can contact it. Talk
to your internet provider or IT personal about how best to do this.
With RMS Send Enabled, you can now set the RMS Schedule Options
RMS Schedule: (Enable/Disable) this turns on and off the Schedule system.
RMS Check Interval: Enter a value in minutes, from 1 to 1400 (1400=23 hours)
This is how often the ATM will attempt to connect to you RMS PC and perform whichever tasks
you specify in RMS. Note that if you set the value to 1 minute, the machine will attempt to
connect to RMS every 60 seconds.
If the system is unable to connect with the RMS PC, then it will reattempt the call again. If that
second attempt fails, then it will wait again until the next Check Interval before trying again
(twice).
Upload Once / 24 Hours: When this is enabled, once the ATM can successfully connect to RMS
and perform the preset tasks, then the ATM will not attempt to connect again for 24 hours.
If you set this to Disabled, then the ATM will continue to connect to the RMS PC at each Check
Interval time
Schedule Start Time: The ATM will begin the counter for 'Check Interval' starting from this time.
RMS Send: Remember that the Schedule system is independent of RMS Send. Which means
that if your ATM goes out of service, and is still hours away from the next Check Interval, the ATM
will always send it's status alert via RMS Send. See page 3.11 for details on how RMS send
works.
Programming 3.13 © Genmega 2011