Table of Contents
Advertisement
Operator Manual
Step 3
Once you have selected Host Phone #1 or Host Phone #2 you will be prompted with the following
screen. Using the numbers on the keypad press the first number of your phone number.
Configuration Scheduled: When this option is set to 'Scheduled', upon backing out of the menu
and going back in service, the ATM will initiate a configuration request with the host and
download a new working key. Because the ATM reboots itself every 24 hours, this option must
be enabled to initiate the request.
Note that if you reprogram the machine, or change any important parameters related to the host,
you should toggle the value to 'scheduled' and update configuration with the host, not doing so
can give you a 'Welcome' screen even though the host is not properly connected resulting in
transactions being denied.
Step 4
Genmega always recommends using a dedicated, data-quality phone line for all ATM
installations, however if you are using a phone line that is dialing out through a PBX type system
(where you dial a number for an outside line), then you may insert commas ( , ) to create a pause
between digits.
For example if you have to dial a 9 to get an outside line try the following:
9,,18005551212
(the 800 number being an example)
NOTE: Entering anything other than a number or a comma in the host phone number field will
cause the ATM not to dial out. Make sure that Zero's and 'O's' are identified properly.
Programming
3.9
© Genmega 2011
Hide quick links:
Advertisement
Table of Contents
