Checking The Genuine Tcms V2; Installation And Setup Of Tcms V2; Connecting The Terminals To Tcms V2; Determining Terminal Number - FingerTec AC900 User Manual

Checking the Genuine TCMS V2

FingerTec TCMS v2
Product Key:
YTR1-4AWE-9899
S/N: 8203602 Activation Key: K2EWF5SZ
001010
c 2008-2009 HRM System All right reserved.
TCMS V2 is genuine software by FingerTec®. Check the genuine sticker on top of TCMS V2
software manual booklet to retrieve product and activation code. The serial number of the
terminal must match with the serial number printed on the booklet in order to activate the
system.

Installation and Setup of TCMS V2

Install TCMS in a PC with sufficient minimum requirements. Refer to user.fingertec.com/
user-promanual.htm for TCMS V2 Manual online. Setup Wizard will require the product
key and activation code to activate the system. In case you lose TCMS V2 product key and
activation code, go to user.fingertec.com/retrieve_key_user.php for retrieval.

Connecting The Terminals to TCMS V2

DETERMINING TERMINAL NUMBER

Identify the number of your terminal to differentiate between one another. One TCMS V2
can connect to 999 units of terminal. Press Menu > Options > Comm Opt > Dev Num >
Select the number.

USING TCP/IP

Determining the IP Address
IP address is important, as it is a unique address of the terminal in LAN. Without the IP ad-
dress, locating the specific terminal is not possible.
To input the IP address of the terminal: Press Menu > Options > Comm Opt > IP Addr > Key in IP ad-
dress.
Setting up Ethernet
It is important to setup the Ethernet to connect the terminals using TCP/IP connection.
Setting up Ethernet is by enabling the Ethernet function: Press Menu > Options > Comm Opt > Ether-
net > Yes. Turn off the terminal after you have set the Ethernet to Yes. Now, plug the network plug to the
Ethernet interface and turn the power on.
NOTE
By enabling this function, the RS232/RS485 will be disabled.
Determining the Netmask, Gateway and NetSpeed: For TCP/IP connection, please configure the net-
mask, gateway and netspeed for the terminal.
Press Menu > Options > Comm Opt > NetMask > Insert the numbers.
Press Menu > Options > Comm Opt > Gateway > Insert the numbers.
Press Menu > Options > Comm Opt > NetSpeed > Choose the speed of your Ethernet connection
15