Descriptions Of Available Connections; Usb Port; Tcp/Ip Port; Power Supply Port - FingerTec AC900 User Manual

Descriptions of Available Connections

USB PORT

Linking with USB flash disk for remote data transfer.
1 8
TOP
FRONT
1 8
TCP/IP for Network Connection
Ethernet 10/100Base-T Straight Thru Cable or "whips". The cable works with both 10Base-T and 100Base-
TX, connecting a network interface card to a hub or network outlet.

POWER SUPPLY PORT

Insert the Power Adapter point to this port for power.

RS232/RS485/WIEGAND CONNECTION PORT

RS232 –
Connection to a computer using RS232 cable.
RS485 Single Connection
RS485 Network Connection
Wiegand Output

ACCESS CONTROL PORT

Linking the terminal to door lock system.

BELL PORT

Linking the terminal to doorbell.
14

TCP/IP PORT

Connect with CAT 5 cable for LAN connection, one end to this port and
another end to the computer's TCP/IP Port.
TCP/IP for Single Connection
using TCP/IP requires Ethernet 10/100Base-T Crossover Cable. The cable can be
used to cascade hubs or to connect Ethernet stations back-to-back without a hub.
It works with both 10Base-T and 100Base-TX.
JOINT 1 PIN
TX+
TX-
RX+
RX-
–
Linking the terminals to multiple computers using TCP/IP requires
CONNECTOR PIN
•
TX+ 1
•
TX- 2
•
RX+ 3
•
4
•
5
•
RX- 6
•
7
•
8
-
Connection to a single computer using RS485 wire.
-
Connection to multiple computers using Daisy Chain connection.
–
Connecting with third party connector or terminal(s).
NOTE
NOTE
–
Linking the terminal to a single computer
JOINT 2 PIN
• •
1 3
• •
2 6
• •
3 1
• •
6 2
CABLE COLOR
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
Link all cables to the correct connection point(s) be-
fore attempting to connect the terminals to software.
This feature is not available
in AC900
RX+
RX-
TX+
TX-
CONNECTOR
•
1 TX+
•
2 TX-
•
3 RX+
•
4
•
5
•
6 RX-
•
7
•
8