SMC Networks HRS012-A*-10-* Operation Manual page 116

HRX-OM-M090
Chapter 5 Display and setting of various functions
38.
Select contact input signal 2 from the table below with [▲] key or [▼] key, and confirm
by pressing "SEL".
Set value
∗ 7：When the setting of the serial protocol is "Simplified communication protocol 2", "Remote
signal" cannot be set.
Contact input signal 2 type Setting and checking
39.
Press the [SEL] key once.
The set screen of contact input signal 2 type is displayed on the digital display.
PV
SV
40.
Select contact input signal 2 type from the table below with [▲] key or [▼] key, and
confirm by pressing "SEL".
Set value
∗ 8 Can be set when the setting of contact input signal 2 is "Run/Stop signal input" or "Remote signal"
Contact input signal 2 delay timer of reading Setting and checking
41.
Press the [SEL] key once.
The set screen of contact input signal 2 delay timer of reading is displayed on the digital
display.
PV
SV
5.18 Communication function
5-64
Table 5.18-20 List of set value
Explanation
Without input signal
Input of run/stop signal
External switch signal input(N.O. type)
External switch signal input (N.C. type)
∗
7
Remote signal
Table 5.18-21 List of set value
Explanation
Setting/checking are not available if the
setting of contact input signal 1 is OFF.
Alternate signal
∗ 8
Momentary signal
Initial value
(Default setting)
○
Initial value
(Default setting)
○
HRS Series