Installation Summary; Installation Restrictions - NCR RealPOS 70XRT User Manual

2-2 Chapter 2: Installing the Terminal

Installation Summary

•
•
•
•
•

Installation Restrictions

•
•
•
•
•
•
Caution: This unit contains hazardous voltages and should only be serviced by qualified
service personnel.
Caution: DO NOT connect or disconnect the transaction printer while the terminal is
connected to AC power. This can result in system or printer damage.
Remove the terminal from the shipping packaging and verify the hardware configuration.
Connect the peripheral and communication cables.
Attach the Power Cord to the system and to an AC power source.
After power is applied to the terminal the Power-up self-tests run to verify basic
functionality.
ROM-based setup should be used to configure network options. Full configuration
depends upon the system server and the management web site.
Before installing the terminal, read and follow the guidelines in the NCR RealPOS 70 Site
Preparation Guide (B005-0000-1873) and the NCR Workstation and Peripheral AC
Wiring Guide (BST0-2115-53).
Install the terminal near an electrical outlet that is easily accessible. Use the power cord as
a power-disconnect device.
Do not permit any object to rest on the power cord. Do not locate the terminal where the
power cord can be walked on.
Use a grounding strap or touch a grounded metal object to discharge any static electricity
from your body before servicing the terminal.
If the power cord is replaced, it must be replaced with the same type of cord.
Do not route the power cord through openings with sharp edges.