Spi/Bios Updating Procedures - NCR RealPOS 70XRT User Manual

SPI/BIOS Updating Procedures

1. Insert the media containing the SPI/BIOS update software in the 7403.
2.
3. Apply power to the terminal.
4. The terminal boots and displays the SPI/BIOS Update main menu.
5. Make a menu selection and follow the screen prompts (Option 1 is recommended).
Connect a USB keyboard to the terminal.
Important: The update procedure requires two boots from the SPI/BIOS media. Be sure
to set your boot order accordingly to make this happen. You can change the boot order
temporarily in the BIOS Setup Boot Menu or you can press
the NCR logo) to enter the Boot Select menu.
•
If you are using the integrated CD/DVD Drive select CD/DVD:P1-DV-28S-V.
•
If you are using the external USB CD Drive select
•
If you are using a USB Memory Drive select
There are six options from the main menu to run the update program. Three run
automatically and two are interactive. Option 1, the Automatic SPI and BIOS Update
executes automatically in 10 seconds unless the up/down arrow is pressed.
Automatic Method
With this method you see a prompt for terminal Class/Model/Serial information if the
program detects invalid information in the current BIOS, or if you are replacing the
processor board, in which case there is no Class/Model/Serial information in the BIOS.
Important: I information is mandatory.
Interactive Method
This method permits you to input/replace the Class/Model/Serial information that is stored
in the BIOS.
Note: DMI information that is currently stored in the BIOS is displayed during power up.
Press at the NCR Logo to remove the logo. Press
[Tab]
Press to continue.
[Esc]
1 Update SPI and BIOS – No prompt for Serial/Model/Class unless invalid
2 Update BIOS only
***** Forced Update of Serial/Model/Class Information *****
3 Update DMI only – Serial/Model/Class update ONLY (no BIOS or SPI Update)
4 Update of SPI and BIOS – Always prompts for Serial/Model/Class
5 Update of BIOS only
***** For Service Personnel Only *****
6 Update of SPI and BIOS – Reset to Default Serial/Model/Class information
USB:xxxx
– No prompt for Serial/Model/Class unless invalid
– Always prompts for Serial/Model/Class
Chapter 13: BIOS Updating Procedures 13-3
during boot (when you see
[F8]
USB:TEAC CD-W552E.
xxx.
to freeze the screen.
[Pause]