Table of Contents
Advertisement
Chapter 2:
Installation Restrictions
Workstation Hardware Installation
This chapter discusses procedures for performing an out-of-box
hardware installation of the 7452 Workstation hardware.
•
Before installing the 7452 read and follow the guidelines in the 7452
Workstation Site Preparation and the Workstation and Peripheral AC
Wiring Guide.
•
Install the 7452 near an electrical outlet that is easily accessible. Use
the power cord as a power disconnect device.
•
Do not permit any object to rest on the power cord. Do not locate
the 7452 where the power cord can be walked on.
•
Use a grounding strap or touch a grounded metal object to
discharge any static electricity from your body before servicing the
7452.
Warning: DO NOT connect or disconnect the transaction printer
while the workstation is powered on. This can result in system or
printer damage.
Caution: This unit contains hazardous voltages and should only be
serviced by qualified service personnel.
Caution: The power supply in this unit must be set to match the
proper voltage requirements (115V or 230V). The AC Selector switch is
located behind the Back Panel, on the Power Supply. The switch must
be set before plugging the power cord into an AC outlet.
Advertisement
Table of Contents
