Software Requirements - NCR RealPOS 70XRT User Manual

10-2 Chapter 10: Wedge to USB MSR Software Migration

Software Requirements

The software that supports the USB MSR is available in the Retail Platform Software for
Windows (RPSW), version 1.3.0 (or later).
Setting up the software to support the USB MSR requires two components. The first is to have
the OPOS Service Object and supporting DLL installed on the system, and the second is to
have the OPOS Profile configured properly to use this software.
1. OPOS Service Object and Supporting DLL
2. The OPOS Profile must have the following properly configured:
RPSW versions 1.5.2 (and above) installs the correct DLLs onto the system when default
installation options are chosen, but they do not create a default profile that uses the MSR.
RSPW versions 3.0.1.0 (and later) does create a default profile (NCRMSR.2) that uses the
NCRFitClient.MSR. However, the MSR Interface is set to Integrated. Changing this to
USB creates a profile that works with the 7403 USB MSR.
For RPSW versions before 1.5.2 the DLLs required to use the USB MSR are not installed by
default configuration selections. In order to use these versions with the USB MSR a modified
installation must be performed. The NCR5932 Service Object feature must be added when
performing the installation. A default profile (NCRMSR.3) is created and properly configured
during installation to use the USB MSR.
On your current Wedge MSR you are most likely using either the default OPOS Wedge profile
(NCRMSR.1) or a profile with a name of your choice, which is configured the same as the
default profile. If you want to keep the same profile name you must replace the existing Wedge
configured profile with a profile by the same name configured to use the USB MSR. Below is
the default NCRMSR.3 profile showing the proper configuration options for using the USB
MSR.
[HKEY_LOCAL_MACHINE\SOFTWARE\OLEforRetail\ServiceOPOS\MSR\NCRMSR.3]
@="NCRFitClient.MSR"
"Description"="NCR 74XX MSR Service Object"
"MSR"="USB"
"NCRVersion"="2.4.1.0 -> NCR Release File Version"
"ProductID"="0 -> ProductID: Maximum 0xFFFF hex"
"TimeOut"="800"
"Type"="ISO"
"VendorID"="0 -> VendorID: Maximum 0xFFFF hex"
"Version"="1.3.0"
Nortice the default value for the Programmatic ID is NCRFitClient.MSR and that the MSR
type is USB. The VendorID and ProductID are 0 so any USB MSR that is detected will be
used.
IMPORTANT NOTE:
The
This must be
will not work.
•
Service Object:
NCRMSR.DLL
•
Supporting file:
NCRHID_DLL.DLL
•
Programmatic ID:
NCRFitClient.MSR
•
MSR Interface:
USB
NCRFitClient.MSR
(set to False) for USB MSR. If it is set to
Disabled
profile through FitClient LE or RSM LE has an option for Tone.
(True) the MSR
Enabled