NCR RealPOS 70XRT User Manual page 134

13-4 Chapter 13: BIOS Updating Procedures
Option 1 – Update SPI and BIOS – No prompt for Serial/Model/Class unless invalid
1. Highlight Option 1 and press [ENTER]. (Executes automatically in 10 seconds unless the
2. The Flash Program updates the SPI/BIOS, automatically powers down, and then reboots
3. After a few seconds the terminal reboots again.
4. As the terminal reboots select the boot media again
5. Let the terminal boot from Option #1 (default).
6. The Manageability Engine (ME) is programmed and a message is displayed indicating
7. Remove the SPI/BIOS Update media before the system boots.
8. System is ready for operation.
Option 2 – Update BIOS only – No prompt for Serial/Model/Class unless invalid
This option automatically updates the BIOS only.
1. Highlight Option 2 and press [ENTER].
2. The Flash Program updates the BIOS and automatically reboots the terminal.
Option 3 – Update DMI only - Serial/Model/Class update ONLY (no BIOS or SPI Update)
This option lets you enter the DMI information only. The SPI and BIOS are not updated.
1. Highlight Option 3 and press [ENTER].
2. At the prompt press
3. Press
4. Remove the BIOS Update media before the system boots.
5. System is ready for operation.
up/down arrow is pressed.)
the terminal.
boot from the SPI/BIOS media.
power must be removed before continuing. Press
removal (automatically executes in 2 minutes if no keys are pressed).
[ENTER]
Follow the onscreen format instructions.
Example:
7403-5000-8801
54-19378230
to confirm the data and to continue.
1
[F8]
[3]
to enter the Class/Model/Serial Number information (DMI).
[ENTER]
[ENTER]
(if necessary) to have the terminal
to perform a 20 second AC power