Installation Summary; Installation Restrictions - NCR RealPOS 70XRT User Manual

2-2 Chapter 2: Installing the Terminal

Installation Summary

•
•
•
•
•

Installation Restrictions

•
•
•
•
•
•
Warning:
qualified service personnel.
Warning:
is connected to AC power. This can result in system or printer damage.
Warning:
is connected to AC power. This can result in system or printer damage.
Remove the terminal from the shipping packaging and verify the hardware
configuration.
Connect the peripheral and communication cables.
Attach the Power Cord to the system and to an AC power source.
After power is applied to the terminal the Power‐up self‐tests run to verify basic
functionality.
ROM‐based setup should be used to configure network options. Full
configuration depends upon the system server and the management web site.
Before installing the terminal, read and follow the guidelines in the NCR RealPOS
70 Site Preparation Guide (B005‐0000‐1873) and the NCR Workstation and Peripheral
AC Wiring Guide (BST0‐2115‐53).
Install the terminal near an electrical outlet that is easily accessible. Use the power
cord as a power‐disconnect device.
Do not permit any object to rest on the power cord. Do not locate the terminal
where the power cord can be walked on.
Use a grounding strap or touch a grounded metal object to discharge any static
electricity from your body before servicing the terminal.
If the power cord is replaced, it must be replaced with the same type of cord.
Do not route the power cord through openings with sharp edges.
This unit contains hazardous voltages and should only be serviced by
DO NOT connect or disconnect the transaction printer while the terminal
DO NOT connect or disconnect any serial peripherals while the terminal