NCR RealPOS 70XRT User Manual page 135

Option 4 – Update of SPI and BIOS – Always prompts for Serial/Model/Class
This option is similar to Option 1 above except you are prompted for Class/Model/Serial
information at the beginning of the program. You also have to select which type of update to run,
BIOS or SPI.
1. Highlight Option 4 and press [ENTER].
2. At the prompt press
[ENTER]
Follow the onscreen format instructions.
Example:
7403-5000-8801
54-19378230
3. Press to confirm the data and to continue.
1
4. The Flash Program updates the SPI/BIOS, automatically powers down, and then reboots
the terminal.
5. After a few seconds the terminal reboots again.
6. As the terminal reboots select the boot media again
boot from the SPI/BIOS media.
7. Let the terminal boot from Option #1 (default). The Manageability Engine (ME) is
programmed at this time.
8. At the prompt:
(Press <0> for command prompt, or <3> to reboot (automatic in 10 seconds)
press to reboot.
[3]
9. A message is displayed indicating power must be removed before continuing. Press
perform a 20 second AC power removal (automatically executes in 2 minutes if no keys
are pressed).
10. Remove the BIOS/SPI Update media before the system boots.
to enter the Class/Model/Serial Number information (DMI).
[ENTER]
[ENTER]
[F8]
Chapter 13: BIOS Updating Procedures 13-5
(if necessary) to have the terminal
to
[3]