NCR RealPOS 70XRT User Manual page 58

3-4 Chapter 3: Touch Screen Calibration
a. Touch the center of the target. Pull your finger a few inches away from the screen
when you see the Release message.
For best results:
•
Face the monitor directly.
•
Perform the calibration in the position (sitting or standing) that you normally
expect to use the touch screen.
•
Touch the calibration target firmly and precisely with your fingertip. During
calibration, be careful to keep your fingernails and other fingers away from the
touch screen as you touch each target.
b. Repeat the process for each target location as they pop up.
c. After all targets have been touched a test screen appears. Touch the screen in various
locations to verify the calibration results. Select
results. If not, repeat the process.
Note: Do not touch to exit from this screen.
ESC
if you are satisfied with the
Accept