NCR RealPOS 70XRT User Manual page 136

13-6 Chapter 13: BIOS Updating Procedures
Option 5 – Update of BIOS only – Always prompts for Serial/Model/Class
This option prompts for Class/Model/Serial information at the beginning of the program and
then updates the BIOS only.
1. Highlight Option 5 and press [ENTER].
2. At the prompt press
3. Press
4. The Flash Program updates the SPI/BIOS and automatically reboots the terminal.
Option 6 – Update SPI and BIOS – Default Serial/Model/Class information
This option is for Service Personnel only. It updates the SPI and BIOS but leaves the
Class/Model/Serial fields empty (erased). The DMI information is then entered when the board
is installed in a terminal.
1. Highlight Option 6 and press [ENTER].
2. The SPI and BIOS are updated and the system reboots (2 times).
3. Remove the SPI/BIOS Update media before the system boots.
4. System is ready for operation.
[ENTER]
Follow the onscreen format instructions.
Example:
7403-5000-8801
54-19378230
to confirm the data and to continue.
1
to enter the Class/Model/Serial Number information (DMI).
[ENTER]
[ENTER]