NCR RealPOS 70XRT User Manual page 96

6-18 Chapter 6: Installing Optional Remote Peripherals
1. Locate the Display Mount within 4 meters (13 ft.) of the host terminal.
2. Determine if the cable should be routed down through the mounting surface or if it should
3. If you are installing with a post greater than 215 mm (8.5 in.) secure the Base Plate with
4. Connect the Interface Cable to the Display Module.
be run on top of the surface. Drill a hole if necessary.
screws (4) that are provided.
a. Remove the screws (2) from the Display Back.
b. Remove the Display Back.
c. Route the Interface Cable though the opening in the Display Back.
d. Connect the cable to the proper connector on the Display Module.
RS-232 Connector
e. Reassemble the Display Assembly.
Display Module
USB Connector
Display Back
22930
Display Front
22909