NCR RealPOS 70XRT User Manual page 98

6-20 Chapter 6: Installing Optional Remote Peripherals
6. Connect the Display Cable to the terminal, based on the type of interface you are using.
USB Interface (Powered)
Connect the I/F cable to a powered 12V Powered USB connector on the terminal.
A B
C
D Line Out
C
RS232/ C
LAN
B
A
MIC RS232/ A
Powered RS-232
RS-232 Interface (Powered)
Connect the I/F cable to a powered RS-232 connector on the terminal.
Note: The factory settings for the COM ports are non-powered by default. To change
a port to powered see the Circuit Boards chapter in the NCR RealPOS 70
Guide, B005-0000-1874.
Configure the terminal serial port as follows:
•
9600 baud
•
8 data bits
•
1 start bit
•
No parity
•
1 stop bit
•
Half-Duplex
F
D E
E F G Cash
RS232/ D
Drawer
RS232/ B
or
12V USB
26243
Service
XRT