Removing Back Panel Of Backguard - Electrolux Next Gen 30" Service Manual

.
Backguard trim screws
4. Remove the two screws in front, the eight screws in
back, disconnect the wires from the oven light and
fluorescent switches and lift the trim off.
Back panel of backguard:
1. Disconnect power from range, remove the backguard
glass and trim.
2. Remove the four screws holding the electronic oven
control bracket to the back panel.
EOC backpanel screws
3. Remove the four screws holding the splash panel to
the back panel.
Splash panel screws
4. Remove the two screws holding the back panel to
the bodysides.
Backpanel/bodyside
5. Remove the screw holding the ground wire to the
back panel.
Ground wire screw
6. Tip the top of the back panel out, release the wiring
from the bottom of the panel and lift the panel off.
115
screws
Wiring