Storage Drawer; Removing Storage Drawer Front Panel; Removing Inside Drawer Panel; Removing Drawer Glides - Electrolux Next Gen 30" Service Manual

Removing the storage drawer front panel:
1. Remove two screws upper inside panel.
Two inside screws
2. Remove two screws bottom edge of the panel.
Two bottom edge screws

Removing inside drawer panel:

1. Remove four screws, two on each side, holding the
inner panel to the drawer.
Two screws on each side

Removing drawer glides:

There are four drawer glides mounted to the drawer, one
on each side in the front and one on each side in the
rear:
1. Press in on the locking tab and pull the glide
from the drawer.
There are two drawer glides mounted to the frame of the
range, one on each side in the front.
1. To remove the glide it is necessary to get behind the
frame of the range, but when reinstalling, it snaps
into place. If the glide is going to be replaced break
it out. If the same glide has to be reinstalled it is
necessary to remove the bodyside to get to the tab.

Removing the warmer drawer:

1. Pull the drawer out to the stop.
2. There is a latch on each of the drawer glides. Lift the
latch on the right side and push down on the latch on
the left side and pull the drawer the rest of the way
out.
111
Locking tab
Drawer glide