Oven Door - Electrolux Next Gen 30" Service Manual

Burner box :
1. To remove the burner box disconnect power, remove
the main top, burner box side panels,control panel,
burners, manifold pipe, lock mechanism, and splash
panel.
2. The burner box is held to the front frame by four
screws and to a spacer at the rear of the lock
mechanism opening by one screw.
Burner box screws
3. Remove the back cover from the rear of the range
then remove the two screws at the reat of the burner
box that hold the lock switch bracket to the burner
box.
Lock switch bracket screws
4. Remove the one screw holding the burner box to the
splasher panel, the four screw holding the burner
box to the top of the rear panel and lift the burner
box out.
More screws

Oven Door

Oven door seal:
1. The oven door seal is snapped into a hole in the
inner door panel by spring clips.
2. To remove the seal pull up on the seal.
Door seal spring clips
Oven door removal:
1. Open the door to the broil stop positionand lift the
door off.
Broil stop position
Oven door trim:
1. The oven door trim is held to the inner liner by four
screws, two at the bottom and one on each side at
the top.
121