Removing Manifold Panel; Replacing Ignitor Switches And Harness; Replacing Surface Burner Valves - Electrolux EW30GF65G Series Product & Training Manual

Wave-touch and iq touch freestanding gas ranges

Hide thumbs

Table Of Contents

Table of Contents

Remove the four mounting screws indicated in

photo A on the underside of the manifold panel.

Remove the burner valve control knobs by pulling

them straight forward off the valve shafts.

Next remove the ¼" hex head screws securing

each of the main top mounting clips. Remove the

1/4" hex head screw in the center of the manifold

panel and remove the panel from the range.

(Photo B)

With the manifold panel removed the surface

burner ignitor switches and harness are

accessible. The wire harness and switches are

replaced as a complete assembly.

To remove the switches and harness from the

burner valves loosen the wire twist ties that

secure the wire harness to the manifold pipe.

(Photo C)

Pull forward to unsnap the switch housing from

the valve. (Photo D).

When replacing the switches make sure that the

switches snap securely and lock to the valve

body. The slack in the wire harness should lay

under the manifold tube and secure with the wire

twist ties as shown in the photo.

Disconnect the compression nut that secures the

orifice holder assembly gas line to the valve.

Remove the valve mounting screw from the top

side of the manifold tube. The valve can now be

pulled out of the manifold tube from the bottom.

IMPORTANT NOTE:

burner valve always insure that the washer on

the burner screw and valve body is undamaged

and properly positioned