Converting To Lp; Tools Required For Lp Conversion - Electrolux Next Gen 30" Service Manual

Instructions for converting range to operate on Liquefied Petroleum Gas
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
This conversion kit must be installed by a qualified service technician in accordance with
the manufacturer's instructions and all applicable codes and requirements of the authority having
jurisdiction. Failure to follow instructions may result in fire, explosion or production of carbon monoxide
causing property damage, personal injury or loss of life. The qualified service agency is responsible for
the proper installation of this kit. The installation is not proper and complete until the operation of the
converted appliance is checked as specified in the manufacturer's instructions supplied with this kit.
Before proceeding with the conversion, shut off the gas supply before disconnecting
electrical power to the range. Be sure both power supplies are off before installing the conversion kit.
Failure to do so could cause serious bodily injury.
Determine the combination of top burners that are featured on your range. Then identify the parts you
need from this kit to completethe LP conversion. When burners are converted from Natural to LP the BTU
rating is as follows:
5,000 BTU* Natural Gas to 4,500 BTU* LP Gas
12,000 BTU* Natural Gas to 10,000 BTU* LP Gas
Quantity Part Number
1 316037526
1 316248105
1 316005215
1 316005216
1 316005217
1 316005218
1 316005219
1 316005220
1 316005221
1 316005222
1 316241200
1 316237904
1 316237905
1 316237906
1 316237907
*Note: For operation at elevations above 2000 ft., appliance rating shall be reduced at the rate of 4 percent
for each 1000 ft. above sea level.
IMPORTANT: After replacing the natural gas to LP orifices, be sure to keep the original factory installed
natural gas orifices for future range conversion back to natural gas. The factory orifices are marked with
101 for 5,000 BTU; 154 for 9,500 BTU; 175 for 12,000 BTU and 193 for 14,000 BTU.
Tools Required for L.P. Conversion:
3/8", 1/2" and 5/8" Open End Wrench
1/8" Wide Flat Blade Screwdriver
7mm Nutdriver
INSTALLATION AND SERVICE MUST BE PERFORMED BY
A QUALIFIED INSTALLER.
Part Description
L.P. Conversion Kit Label
Instructions for converting range to LP Gas
Rating Plate - English
Rating Plate - English
Rating Plate - English
Rating Plate - English
Rating Plate - French
Rating Plate - French
Rating Plate - French
Rating Plate - French
L.P. Conversion Label
Orifice - 11,000 BTU*
Orifice - 10,000 BTU*
Orifice - 8,000 BTU*
Orifice - 4,500 BTU*
9,500 BTU* Natural Gas to 8,000 BTU* LP Gas
14,000 BTU* Natural Gas to 11,000 BTU* LP Gas
English & French
English, French & Spanish
4 - 8K
3 + 1
2 + 1 + 1
1 + 1 + 1 + 1
4 - 8K
3 + 1
2 + 1 + 1
1 + 1 + 1 + 1
English, French & Spanish
RED
GREEN
NO COLOR
BLUE
20
Notes