Electrolux Next Gen 30" Service Manual page 129

Oven sensor mounting screws
Spark module:
1. Disconnect power, remove the rear cover and unplug
the wire from the module.
2. The module is held to the rear panel of the range by
two tabs, one at the bottom and one at the top that
go into two slots in the rear panel of the range. To
remove the module take a standard screw driver and
push up on the bottom tab.
Spark module mounting tabs
Lock switch:
1. The lock switch is held to the lock switch bracket
by two bolts and nuts.
2. To remove the lock switch, disconnect power, remove
the rear cover, disconnect the switch wires, and
remove the two bolts and nuts.
Lock switch bolts and nuts
Bodyside panels:
1. Disconnect electrical power, remove the main top,
control panel and front filler panel on the side of the
bodyside to be removed.
2. Remove five screws holding the back of the bodyside
to the rear of the range and and one screw holding
the bodyside to the front frame in the control panel
area.
Rear screws
3. Remove one screw at the lower front, one screw at
the top of the panel holding the nylon main top locator.
Lift the panel off.
Lower front
129
Front screw
Top bracket