Section D - Disassembly And Replacement Of Parts; 30" Gas Ranges; Removing Backguard Back Panel; Removing Infinite Switches - Electrolux Next Gen 30" Service Manual

SECTION D - DISASSEMBLY AND PARTS
REPLACEMENT
30"RANGE
Backguard back panel:
1. Disconnect power from range.
2. Remove six screws and lift the panel off.
Backguard back panel
Note: Screws may be removed using either a 1/4" nut
driver or an S1 square drive.
1/4"
Infinite Switches used for surface elements, warm
and serve zone, and warming drawer (if equipped:
Infinite switch
1. Disconnect power from the range.
2. Remove the back panel from the backguard.
3. Mark and disconnect the wires from the infinite
4. Remove the knob by pulling straight off.
5. Remove the two phillips-head screws holding the
S1
6. Pull the switch from the back of the range.
96
switch.
Knob
switch to the control panel.
Two Screws