Removing The Manifold Pipe; Removing Oven Door Seal; Removing Oven Door - Electrolux Next Gen 30" Service Manual

Removing the manifold:
1. Disconnect electrical power and turn the gas supply
off.
2. Remove the main top, manifold panel and burner
pan.
3. Remove the top burner valves.
4. Remove the small panel from the rear of the range
that covers the tubing from the pressure regulator to
the manifold by removing one screw.
Small panel
5. Using a 9/16" wrench disconnect tubing from the
pressure regulator and slide the manifold out the
front.
Disconnecting tubing from pressure regulator
Removing the latch mechanism:
1. Disconnect electrical power and turn the gas supply
off.
2. Remove the main top, manifold panel and burner
pan.
3. Remove the two screws holding the latch to the front
frame and slide the latch back.
To remove oven door seal:
1. The oven door seal is snapped to the inner door with
wire clips. To remove the seal pull up on the seal.
Door seal and clips
To remove oven door:
1. The oven door is held to the oven door hinges by two
screws. (One in each hinge.)
2. To remove the oven door remove the two screws.
3. Close the door to the broil stop position and lift up.
Oven door hinge screws
101
Latch screws