Table of Contents
Advertisement
Before Setting Oven Controls
Arranging, Removing, and Replacing Oven Racks
IMPORTANT! Remove all oven racks, rack ladders, and any other accessories from the oven before starting a self clean
cycle.
•
To arrange - Always arrange the oven racks when the oven is cool (prior to operating the oven).
•
To remove - pull the oven rack straight forward until it reaches the stop position. Lift up front of oven rack slightly and slide
out. For ease of removal, racks should not be placed in adjacent rack positions.
•
To replace - place the oven rack on the rack guides on the oven walls. Tilt the front of the rack upward slightly and slide the
oven rack back into place.
•
To prevent possible damage to the oven, do not attempt to close the oven door until all oven racks are fully positioned inside
the oven cavity.
Installing Oven (Ladder) Rack Supports
IMPORTANT! Always install oven rack support before turning on the oven (when the oven is cool).
To aid installation of the porcelain oven rack supports, apply a thin layer of cooking oil to all the prongs of the supports shown
below.
To install oven rack supports:
1.
Hold the oven rack support at a slight angle and insert prongs into the holes at the top of the oven cavity (Arrow 1).
2.
Lift the rack into the top holes, aligning the bottom prongs with the bottom holes (Arrow 2).
3.
Once the upper prongs are in place, hold the oven rack support flush with the oven side and insert the bottom prongs into
the bottom holes (Arrow 3).
4.
Slide the bottom prongs down into the lower holes. Some force may be required to set the rack into place (Arrow 4).
Note: To remove the ladder rack support for a self-clean cycle, reverse the order used when installing the ladder rack
supports.
Top prong inserts
into oven piercing
Bottom prong inserts
into piercing to make
support flush with
oven wall
15
Advertisement
Table of Contents
