Installation Of New Lp/Propane Rating/Serial Plate; Conversion To Natural Gas - Electrolux Next Gen 30" Service Manual

a. Pull the bearing glides to the front of the chassis
glide (See Figure 15).
b. Align the glide on each side of the drawer with the
glide slots on the range.
c. Push the drawer into the range until levers "click"
(approximately 2"). Pull the drawer open again to
seat bearing glides into position. If you do not hear
the levers "click" or the bearing glides do not
feel seated remove the drawer and repeat
steps "a" through "c". This will minimize possible
damage to the bearing glides.
Figure 15
10. Installation of New LP/Propane Rating/Serial
Plate
Record the model and serial number on the LP/Propane
Rating/Serial plate provided in this kit. The information
can be obtained from the existing Rating/Serial plate.
Place new plate as close as possible to the existing
Rating/Serial plate on range (See the recommended
locations shown in Figure 16).
Figure 16

CONVERSION TO NATURAL GAS

If it becomes necessary to convert the range back to
natural gas:
a. Disconnect gas and electrical supply from range.
b. Convert pressure regulator (See step 1), turn cap
over so the solid end of cap faces outward. Place the
hollow end of the cap into the loop end of the dust
protector.
c. Remove the four LP orifices using 7mm nutdriver and
replace with the four original factory installed natural
gas orifices at their original locations (See figure 4 for
locations).
d. Convert Oven Burner Orifice for Natural Gas by
loosening spud counter-clockwise (approximately
2-1/2 turns; See step 3).
e. Convert Waist-High Broiler Burner Orifice (Self-
Cleaning Models Only) for Natural Gas by loosening
spud counter-clockwise (approximately 2-1/2 turns).
(See step 4.)
f. Readjust "LOW" Setting for Surface Burner Valves
following instructions. (See step 6.)
g. Readjust Oven & Broil Burner Air Shutters. (See
steps 7 & 8.)
25