Removing The Rear Panel; Hidden Bake Element - Electrolux FGES3065P series Service Manual

Section 4 Component Teardown
Figure 56
Cooling Fan
Figure 57
Remove Fan Motor wires & rotate
Cooling Fan assembly couter-clockwise
to release locking tabs

Removing the Rear Panel

Components accessible with Rear Panel Removed:
• Bake, Broil, & Convection Elements
• Convection Motor(s)
• ESEC Relay Board
• Terminal Block
Figure 58
Broil Element
Wires
Convection
Element Wires
Convection
Fan Motor
Terminal Block
Bake Element
Wires
4-4
Thermal
Fuse
Remove two (2) screws
& two (2) wires to
remove Thermal Fuse
ESEC Relay
Board
To remove the Rear Panel:
1. Slide the range forward to access Rear Panel.
2. Remove eleven (11) screws securing Rear Panel to
back of range. See Figure
3. Reinstall in reverse order.
Figure 59
Remove eleven (11) screws to remove Rear Panel

Hidden Bake Element

To remove the Hidden Bake Element:
1. Remove the Rear Panel (see
Panel" on page 4-4 ).
2. Disconnect the two (2) wires from the Bake Element.
See Figure 58.
3. Remove the storage drawer or warmer drawer (some
models). Locate the Hidden Bake Element Service
Panel mounted to the bottom of the oven; the top
of the storage drawer or warmer drawer cavity. See
Figure 60.
Figure 60
4. Remove three (3) screws securing the Hidden Bake
Element Service Panel to the bottom of the range.
Element and Panel will hinge down. See
5. Remove Element and Panel assembly.
59.
"Removing the Rear
FRONT of Range
Figure 60.