Brother MFC9100C Service Manual page 93

(4) As shown with arrows
actuator.
(5) Unhook the actuator spring and remove the cassette sensor actuator.
(6) Pull the latch and take out the paper ejection/cassette sensor PCB.
n n
Reassembling Notes
• When setting the lower paper chute back into place, fully turn the arm 12.3 ASSY on the main
chassis clockwise (when viewed from the left) as shown below and pull the release lever to the
left and outwards (when viewed from the rear as shown on page IV-51).
• ‚
and , press the arm and take out the paper ejection sensor
IV - 52