1.21 Main Chassis
(1) Take off the cable clip by removing the screw.
(2) Pull up the three harnesses (paper ejection/cassette sensor harness, paper width/registration
sensor harness, and carriage motor harness) released in step (1) through cutout "X" provided
in the main chassis.
(3) Pull up the head flat cables through cutout "Y" provided in the main chassis.
(4) Pull out two pieces of plastic tape as shown below to release the three harnesses (VC
harness, paper feed motor harness, and solenoid harness).
(5) Remove the pawled bushing from
the right end of the paper feed
gears & shaft ASSY by pulling its
pawls outwards.
(6) Remove the pawled gear 25 by
pulling its pawl outwards and pull
out the bushing.
(7) Remove the paper feed gears &
shaft ASSY.
Once removed, the components given in this subsection
Caution
require the purge unit adjuster for reassembly. Refer to
Section 3, "ADJUSTMENT" in this chapter.
IV - 48