Brother MFC9100C Service Manual page 62

15) At the front end of the document ejection roller shaft, remove the pawled bushing by pulling its
pawls outwards. At the rear end, pull the bushing outwards and lift up the document ejection
roller ASSY.
16) Remove the three screws and take off the motor bracket.
17) At the front end of the lower LF roller (black) shaft, remove the pawled bushing by pulling its
pawls outwards. At the rear end, pull the bushing outwards and remove the lower LF roller
ASSY.
18) Turn the lower ADF chute upside down.
19) Pull the arm outwards and take it off.
20) At the rear side of the lower ADF chute, remove the gear 19/36 by pulling its pawl outwards.
21) Remove the gear 64 by pulling its pawl outwards.
22) Unhook the two springs.
23) Pull out the white roller bushing F by pulling its pawls outwards.
24) Remove the white roller together with the white roller bushing R and gear 27.
IV - 21