Brother MFC9100C Service Manual page 304

12
Only during initial ink cartridge
installation, the screen shows.
Check the print quality of the test sheet. If it is not good, clean the print
head again, by pressing
OK for each color. Press
several colors. After cleaning is finished, press
The MFC starts printing Test Sheet No. 2.
13
Adjust the Vertical Alignment by following the instructions printed on the
Test Print page.
WARNING
If ink gets in your eyes, irrigate them with water immediately and consult
a doctor if you are concerned.
Caution
DO NOT remove ink cartridges if you do not need to replace them. If you
do so, it may reduce the ink quantity and the MFC will not know the
quantity of ink left in the cartridge.
DO NOT shake the ink cartridges. If you do so, the ink may spill when
you take off the sealing tape. If ink stains your body or clothing, wash
with soap or detergent immediately.
If you install an ink cartridge in the wrong color position, you must clean
the print head several times after correcting the cartridge installation and
before you start printing because the colors were mixed.
Once you open an ink cartridge, install it in the MFC and use it up within
six months of installation. Use unopened ink cartridges by the expiration
date written on the cartridge package.
DO NOT refill the ink cartridges. Attempting to use refilled cartridges
may cause damage to the print head and will void your warranty.
If the INK EMPTY error message is on the screen display after you have
installed the ink cartridges, check and make sure that the ink cartridges are
installed correctly.
. The screen will ask you if the print quality is
2
for any color with a problem. You can choose
2
A S S E M B L Y A N D C O N N E C T I O N S
PRINT OK?
1.YES 2.NO
.
Start
2 - 11