1.33 Disassembly of Paper
Feed Frame ASSY
(1) Remove two screws "a" and take off the PF side frame L.
CAUTION: Do not place the paper feed frame ASSY with the PF side frame R facing down.
Doing so will deform the purge unit supports.
(2) Remove four screws (two "b" and two "c") and take off the PF side frame R.
(3) Unhook the three latches and separate the upper paper chute from the paper feed frame.
CAUTION:
sections shown below which are used as the positioning face of the paper leading edge.
n n
Reassembling Notes
•
Take care not to contaminate the upper paper chute, separation pad, and rollers with grease
applied to the paper feed frame.
Caution
Caution
When separating the upper paper chute, take care not to scratch hatched
Once removed, the components given in this
subsection require the purge unit adjuster for
reassembly. Refer to Section 3, "ADJUSTMENT" in
this chapter.
"a" and "b": Taptite, cup S M3x6
"c":
IV - 69
Taptite, cup B M3x10