Frequency Conversion Coefficient; Stop Key Selection; Free-Run Stop Selection And Stop Selection - Omron 3G3JX User Manual

4-2 Function Mode

Frequency Conversion Coefficient

This function displays a conversion value obtained by multiplying the Inverter output frequency by
the coefficient set in [b086]. This helps display the actual physical value on the monitor.
Parameter No.
b086
Related functions
Displayed value [d007] = "Output frequency [d001]" x "Frequency conversion coefficient [b086]"
4
(Display) [d007]
0.00 to 99.99
100.0 to 999.9
1000. to 9999.
1000 to 3996
(Setting range) [b086]
0.1 to 99.9
(Example) When the output frequency [d001] = 50.0 Hz, and
the frequency conversion coefficient [b086] = 1.1,
the monitor [d007] displays "55.0" through 50.0 × 1.1 = 55.0.

STOP Key Selection

You can select whether to enable the STOP key on the Digital Operator, even if the RUN command
is set to the control terminal block (terminal).
Parameter No.
b087
•The trip reset function via the STOP/RESET key works according to this setting.

Free-run Stop Selection and Stop Selection

You can select the operation to be performed when the free-run stop input is reset, and select the
stop method, deceleration stop or free-run stop.
Parameter No.
b088
b091
Related functions
For details, refer to "Free-run Stop" (page 4-53) in the Multi-function Input section.
4-39
Function name
Frequency conversion
0.1 to 99.9
coefficient
: Displays in increments of 0.01.
: Displays in increments of 0.1.
: Displays in increments of 1.
: Displays in increments of 10.
: Can be set in increments of 0.1.
Function name
00: Enabled
STOP key selection
01: Disabled
Function name
00: 0 Hz start
Free-run stop selection
01: Frequency pull-in restart
00: Deceleration → Stop
Stop selection
01: Free-run stop
Data Default setting
d007
Data Default setting
Data Default setting
C001 to C005, b003
Unit
⎯
1.0
Unit
⎯
00
Unit
⎯
00
⎯
00