Omron 3G3JX User Manual page 129

Parameter No. Function name
Multi-function input 1
C001
selection
*2nd multi-function input
C201
1 selection
Multi-function input 2
C002
selection
*2nd multi-function input
C202
2 selection
Multi-function input 3
C003
selection
*2nd multi-function input
C203
3 selection
Multi-function input 4
C004
selection
*2nd multi-function input
C204
4 selection
Multi-function input 5
C005
selection
*2nd multi-function input
C205
5 selection
Multi-function input 1
C011
operation selection
Multi-function input 2
C012
operation selection
Multi-function input 3
C013
operation selection
Multi-function input 4
C014
operation selection
Multi-function input 5
C015
operation selection
* To switch to the 2nd control, allocate 08 (SET) to the multi-function input terminal and then turn it on.
Note 1: The terminal with "18" (RS) allocated will automatically have an NO contact specifications.
Note 2: "19" (PTC) can only be allocated to multi-function input 5 (C005).
Note 3: "64" (EMR) is set forcibly with switch S8, not with parameters.
Data
00: FW (forward)
01: RV (reverse)
02: CF1 (multi-step speed setting binary 1)
03: CF2 (multi-step speed setting binary 2)
04: CF3 (multi-step speed setting binary 3)
05: CF4 (multi-step speed setting binary 4)
06: JG (jogging)
07: DB (external DC injection braking)
08: SET (2nd control)
09: 2CH (2-step acceleration/deceleration)
11: FRS (free-run stop)
12: EXT (external trip)
13: USP (USP function)
15: SFT (soft lock)
16: AT (analog input switching)
18: RS (reset)
19: PTC (thermistor input)
20: STA (3-wire start)
21: STP (3-wire stop)
22: F/R (3-wire forward/reverse)
23: PID (PID enabled/disabled)
24: PIDC (PID integral reset)
27: UP (UP/DWN function accelerated)
28: DWN (UP/DWN function decelerated)
29: UDC (UP/DWN function data clear)
31: OPE (forced operator)
50: ADD (frequency addition)
51: F-TM (forced terminal block)
52: RDY (ready function)
53: SP-SET (special 2nd function)
64: EMR (emergency shutoff)
255: No function
00: NO
01: NC
• NO contact: "ON" with the contact closed,
"OFF" with the contact open.
• NC contact: "ON" with the contact open.
"OFF" with the contact closed.
• For the RS terminal, only NO contact is
available.
4-2 Function Mode
Default setting Unit
⎯
00
⎯
01
⎯
18
⎯
12
⎯
02
⎯
00
⎯
00
⎯
00
⎯
00
⎯
00
4-44
4