2Nd Control Function And Special 2Nd Function - Omron 3G3JX User Manual

4-2 Function Mode

2nd Control Function and Special 2nd Function

This function is used to operate by switching two different types of motors.
Data
08
53
Related functions
4
•By allocating 08 (SET) or 53 (SP-SET) to the desired multi-function input and then turning on/off
the SET or SP-SET terminal, you can switch and control two different motors.
•Switch to the 2nd control function at the SET terminal after turning off the RUN command and the
Inverter output.
•You can switch to the 2nd control function at the SP-SET terminal while in operation.
•To display and set each parameter for the 2nd control (parameter No.200s), allocate the SET
terminal.
•To display and set each parameter for the 2nd control (parameter No.200s), allocate SET and SP-
SET.
•Parameters changeable while in operation are as follows:
4-51
Symbol Function name
SET 2nd control
SP-SET Special 2nd function
U/T1
V/T2
W/T3
Inverter
SET
/SP-SET
SC
Parameter No.
F002/F202 Acceleration time 1
F003/F203 Deceleration time 1
A001/A201 Frequency reference selection
A002/A202 RUN command selection
A003/A203 Base frequency
A004/A204 Maximum frequency
A020/A220 Multi-step speed reference 0
A041/A241 Torque boost selection
Status
ON Enables the parameter for the 2nd motor.
OFF Disables the parameter for the 2nd motor.
ON Enables the parameter for the special 2nd motor.
OFF Disables the parameter for the special 2nd motor.
C001 to C005
Motor
1
Motor
2
Function name
Description
Selection
SET SP-SET
Yes Yes
Yes Yes
No Yes
No Yes
No Yes
No Yes
Yes Yes
No Yes