Setup->Pincode Settings; Setup->Telephony Settings; Destination For Incoming Call; Outgoing Identity To Be Used For - Mitel 5610 IP Dect Stand Configuration And Administration Manual

Configuration and Administration Guide
Setup->Pincode Settings
This web page allows you to set the PINs for accessing the IP DECT stand (via the handset) and
the external tftp account settings.
Setting
Voip Settings Pincode
AC Code
HTTP Server Username
HTTP Server Password
Setup->Telephony Settings
This web page allows you to map handsets to account configurations (DN, PINs, and so forth). It
also provides a mechanism to enforce/restrict handsets to register with a specific stand.

Destination for Incoming call

Check the box of the handset account where you want incoming calls to ring.

Outgoing Identity to be used for

Handset Name
Enter the display name for this handset.
IPEI for Handset
Enter the IPEI information for each handset. Set the option to "Match IPEI to handset" to
"Enable" in environments where stand signals may overlap, such as hospitality. These
settings prevent handsets from registering to the wrong base stand.
DND (Do Not Disturb)
Set Do Not Disturb to "Disabled". If users require the ability to set Do Not Disturb, the MCD
Do Not Disturb feature access code should be entered on the handset to enable it. Note that
if the 3300 Do Not Disturb feature is active on a handset, the user does not receive an
indication, such as stuttered dial tone, to indicate that the feature is active.
CW (Call Waiting)
It is recommended that you set this option to "Disable".
If a user wants to be notified of an incoming call while active on an existing call, activate this
feature. When this option is enabled, a second call placed to the handset will cause a tone to
be played to the handset earpiece and the user can look at the display and see who is
calling. The user can then decide whether to accept or reject the call.
Description
Enter the 3 to 8 digit PIN code that the user
must enter on the handset to access system
menus (for example, System settings).
Enter username for IP DECT Stand web
configurator web interface (default is admin)
Enter password for IP DECT Stand web
configurator web interface (default is admin)
18