Complete Device Programming; Mcd Device Programming - Mitel 5610 IP Dect Stand Configuration And Administration Manual

Configuration and Administration Guide
Note: After you configure the handsets on an IP DECT Stand, ensure that you change the web
configurator interface username and password, and the handset PIN codes from the default values to
prevent unauthorized access.

Complete Device Programming

For MCD platforms, see MCD Device Programming below.
For 5000 CP, see 5000 CP SIP Phone Programming on page 7.

MCD Device Programming

Before you configure a 5610 Cordless Handset on the IP DECT Stand, complete the following MCD
programming tasks. Refer to the MCD System Administration Tool online help for instructions:
1. Program the Mitel IP Phone that is connected to the IP DECT Stand on the MCD.
2. Register the Mitel IP Phone with the MCD.
3. License the 5610 Cordless Handset as a SIP device.
4. Program the 5610 Cordless Handset in the "User and Device Configuration" form or "Multiline IP
Sets" form of the MCD.

For MCD systems with MCD Release 4.0 SPx, program it with a "Generic SIP Phone" device
type, or

For MCD systems with MCD Release 4.1 or later, program it with a "5610 SIP" device type.
When you program the 5610 Cordless Handset with either a "Generic SIP Phone" device
type or a "5610 SIP" device type, the system automatically assigns it with SIP Device
Capabilities index number 68 which contains the recommended SIP devices option settings.

If you assign a User PIN to the handset in the "User and Device Configuration" form, record
the PIN. You will need to enter this User PIN when you configure the handset in the IP DECT
Stand Configurator Web Interface.
5. For MCD systems with MCD Release 4.0 SPx, access the SIP Device Capabilities form.
Program a SIP Device Capabilities index number using the standard defaults with the exception
of the following options. Set the following options to Yes.

Replace System based with Device based In-Call Features

Enable Digit Collection In Busy Or Alerting State

Allow Display Updates

Enable Distinctive Ringing
Use the Search field in the "User and Device Configuration" form to locate the directory numbers
that are assigned to the 5610 handsets. Click the Service Details tab and assign the SIP Device
Capabilities index number to each 5610 handset.
6. In the "Multiline Set Keys" form of the MCD System Administration tool, configure the 5610
Cordless Handset with a second multi-call appearance of the prime line with the Ring Type set to
"Ring". Refer to the MCD System Administration Tool online help for instructions.
6