Register The Handsets With The Ip Dect Stand; Assign An Ip Address To The Ip Dect Stand - Mitel 5610 IP Dect Stand Configuration And Administration Manual

Configuration and Administration Guide
Configure Dynamic Extension Express (Optional)
Dynamic Extension Express (DEE) allows you to associate two or more devices for a single user
under a common main extension number. You can use DEE to "twin" a person's desktop phone and
his or her 5610 Cordless Handset together. The desk phone is considered the main extension, while
the cordless handset is programmed as a secondary destination.
You can also program and label a DEE Handoff key (default feature code is 388) on the user's desk
phone. Users can press the DEE Handoff feature key to push a call that is in progress from their desk
phone to their 5610 Cordless Handset. Note that, as of the v4.0 software release, users cannot pull a
call that is in progress from their 5610 Cordless Handset back to their desk phone.
Refer to the DEE topics in the latest 5000 CP Features and Programming Guide and Database
Programming online help for DEE programming instructions.

Register the Handsets with the IP DECT Stand

To register a handset with the IP DECT Stand (gateway), place the handset in the charging cradle.
The first handset automatically registers with the IP DECT Stand after approximately 30 seconds. To
register each additional handset on the same IP DECT Stand, you must first reboot the stand by
pressing the RESET button on the rear panel of the stand. While the stand is resetting, "Searching for
Gateway" appears in the handset display. Note that you cannot register a handset while a call is
being supported on another handset because you will be unable to reset the stand.
Warning: It takes approximately 30 seconds for a handset to register. Once a handset
has registered, the default handset name appears in the display.
After you register the first handset and after you register each subsequent handset,
you must press the RESET button on the stand before it will accept the registration of
a subsequent handset. Power-cycling the stand will not enable the stand to accept
handset registration due to security.
If you have multiple IP DECT Stands in close proximity of each other (within 50 meters indoors, or
within 300 meters outdoors), you must manually program the handset IPEIs into the IP DECT Stand
using the VoIP Phone Configurator Web Interface. When you manually program the IPEI, it ensures
that the handsets register with the desired stand.

Assign an IP Address to the IP DECT Stand

The IP DECT Stand requires an IP address on the LAN. Either your LAN must be configured with a
DHCP server that automatically assigns an IP address to the stand, or you must manually configure
the stand with a static IP address and subnet mask. To manually configure the stand with a static IP
address and subnet mask:
1. From idle mode, press the OK key, select Settings, and then press OK.
2. Select Network settings and press OK. When prompted for a PIN code, enter the PIN code
(default 0000), and then press OK. When the IP address menu item is shown in red, then the
stand is configured to obtain an IP address dynamically from a DHCP server.
3. Select IP Mode and press OK.
4. Select Static and press OK.
5. Press Back, select IP address, and then press OK.
8