Configure Handsets Via Ip-Dect Stand Configurator Web Interface - Mitel 5610 IP Dect Stand Configuration And Administration Manual

6. Press Erase to delete the current entry (0.0.0.0).
7. Enter a static IP address for the stand. To enter periods in the address, press Options and then
press Insert symbols. Press OK. Save? Appears in the display. Press Yes.
8. Select Subnet mask and press OK. Enter a Subnet mask. Press OK. Save? Appears in the
display. Press Yes.
9. Press Back. You will be prompted to reset the gateway (stand). Press Yes.
10. Press Back repeatedly to return to the main display.After several seconds, "Searching for
Gateway" appears in the handset main display. It takes approximately 30 seconds for the stand to
reset.
11. After the stand resets, it is configured with the static IP address and subnet mask. "Configure SIP
domain" appears in the handset main display.
12. Proceed to Configure Handsets via IP-DECT Stand Configurator Web Interface.

Configure Handsets via IP-DECT Stand Configurator Web Interface

You access the IP-DECT Stand Configurator by entering the IP-address of the handset into the
address field on a web browser, such as Internet Explorer on your PC. The following procedure
covers the minimum configuration required to set up the handsets:
1. Press the Volume Up key on the side of the 5610 Cordless Handset to enter the system status
display. The display shows the MAC address of the handset and the IP address of the IP DECT
Stand. Note that the Boot Status of the handset is displayed as "Failed". Ignore the displayed
boot status because it is not accurate.
2. Record the IP address that is shown in the display: _____________________________.
This IP address is the address of the IP DECT stand.
3. Obtain and record the Handset IDs (IPEIs). On each handset:
Press OK to access the main menu.
-
Select Settings.
-
Press OK.
-
Select Handset ID.
-
- Press OK. The handset IPEI is displayed.
- Record the IPEI:
Handset 1 IPEI: _______________________________
Handset 2 IPEI: _______________________________
Handset 3 IPEI: _______________________________
Handset 4 IPEI: _______________________________
Handset 5 IPEI: _______________________________
Handset 6 IPEI: _______________________________
Handset 7 IPEI: _______________________________
Handset 8 IPEI: _______________________________
- Press Back to exit.
4. Launch a web browser on a PC that is connected to the local network.
5. Enter the IP address (for example http://01.10.106.235) of the IP DECT Stand (from Step 2) in the
browser address field.
9