Ip Dect Stand Led Indicators; Handset Registration; Two Line Support; Message Waiting Indication - Mitel 5610 IP Dect Stand Configuration And Administration Manual

Configuration and Administration Guide

IP DECT Stand LED Indicators

There are four LED indicators on the rear panel of the stand:
LED Status
LAN ON
OFF
VoIP ON
OFF
CALL ON
OFF
POWER ON
OFF
When you power up the stand, or if you reboot the stand, either from the Configurator Web interface
or by pressing the Reset button, the LAN, VoIP and CALL LEDs turn off briefly. During the bootup
sequence, the LAN blinks. After the stand has rebooted, the LAN LED is on solid.

Handset Registration

The IP DECT stand supports the configuration and registration of up to 8 handsets. If the handset is
configured on the stand, it will repeatedly try and register with the MCD, even if the 3300 cannot
recognize the DN or password.
It is imperative that the handset programming in the stand and the MCD match to prevent
unnecessary traffic flow and constant registration failure scenarios. Registration failures are reported
to all handsets, which causes periodic display interruptions to provide the failure notifications. The
user must then clear the display each time.

Two Line Support

The 5610 handset and stand allow two calls to originate from the handset in order to provide transfer
and conference capabilities.
The MCD must be programmed to match this configuration, specifically by adding a second multi call
appearance of the prime DN using the Multi Line Set Key Assignment form.
If the user is involved in a call on line one, he or she hears no audible indication of a call on line two.
The second call continues to alert until call forward no answer is invoked. This prevents callback (on
busy), override, and camp-on from being invoked on these sets.
When both lines are in use, neither line can be manipulated using a mid-call feature access code
such as Call Park. If only one line is active, it can be held, and the call park feature access code
invoked.

Message Waiting Indication

The 5610 handset can obtain voice mail Message Waiting Indication (MWI) from the MCD system.
Although the 5610 handset can support more advanced voice mail features (such as displaying the
number of messages waiting) these features are currently not supported.
44
Description
Stand is connected to the LAN.
Stand is not connected to LAN.
Stand is connected to MCD.
Stand is not connected to MCD.
Call in progress.
No call in progress.
IP DECT stand is powered on.
Power is not connected.