Related Documentation; Registration And Configuration - Mitel 5610 IP Dect Stand Configuration And Administration Manual

Related Documentation

5610 Cordless Handset and IP DECT Stand Installation Guide (part number 57011091): This
guide provides instructions on how to physically connect the IP DECT stand to a Mitel IP Phone,
make the required cable and power connections, and install the handset battery.
RTX4002 DECT Repeater Installation Guide (part number 95100805): The RTX4002 DECT
repeater is an optional unit that allows you to extend the range of your cordless DECT handset.
MCD System Administration Tool Online Help: Refer to this online help system for instructions on
how to program

Mitel IP Phones on the MCD system

5610 IP Cordless phone as a "SIP generic device type" or a "5610 device type" on the MCD
system

5610 IP Cordless phones into personal ring groups

Support for Suite Services.
5000 CP Features and Programming Guide (part number 550.8006) and Database
Programming Online Help: This guide and help provide instructions on how to program 5610 IP
Cordless Handsets as "SIP Phones" on the 5000 CP. Thid documentation also outlines the available
features and limitations when using the 5610 handset with the 5000 CP.
5610 Cordless Handset Quick Reference Guide: This guide provides instructions on how to use
the features of the cordless handset. There are separate versions of this guide for the MCD and 5000
CP.

Registration and Configuration

After you have physically installed the IP DECT Stand to a Mitel IP Phone, you must register the
handsets with the IP DECT Stand. You can then configure the 5610 cordless handsets for operation
either

from a web browser, such as Internet Explorer (recommended method),

through the menu on the 5610 cordless handset, or

via a configuration file that you install on a server in the Local Area Network.
If you perform configuration from the web browser interface or from the handset, you must configure
each handset individually. If you use configuration files, a file must be created for each IP DECT
Stand. The configuration file specifies the parameters of the handsets (up to eight) that are
associated with an IP DECT Stand (see Server Based Configuration on page 32 for details).
To complete registration and configuration, you must

Complete MCD or 5000 CP device programming

Register the handsets with the IP DECT Stand

Assign an IP address to the IP DECT Stand

Configure the 5610 Cordless Handset parameters

Change the handset display name and PIN.
5