Header Levelling
A 1/4 inch (6 mm) shim (A) is located on both
sides of windrower lift linkage. If header is not
level, adjust as follows:
1. Lower header onto a block so back of linkage
lifts.
2. Remove hardware (B) on the high side of the
header and remove shim (A). Replace hard-
ware (B).
3. Check header level. If more levelling is
required, install the removed shim on opposite
side of linkage, adding it to the existing shim.
4. If header is still not level, additional shims are
available from your dealer.
Form # 46584
OPERATION
49
B
A
HEADER LEVELLING
Issue 11/06 Web Rev_01