MacDon 9250 Operator's Manual page 26

Header Controls (continued)
REEL HEIGHT SWITCH (E) - Press top of switch
to raise reel and bottom to lower. Hold switch until
reel reaches desired position.
NOTE: For Auger Headers with Hay Conditioners
equipped with Hydraulic Roll Opener cylinders,
switch (E) controls the operation of these
cylinders.
HEADER HEIGHT SWITCH (F) - Press top of
switch to raise header and bottom to lower. Hold
switch until header reaches desired position. (See
"Cut Height Indicator").
NOTE: Handle may be rotated on lever to allow
the operator to position switches (E) and (F) for
maximum comfort. To adjust, loosen setscrews on
back of handle.
IMPORTANT: Do not continue pressing
switches (E) or (F) after header or reel travel is
complete. If switch is held for a long period of
time, damage may occur due to overheating
electrical solenoids
hydraulic oil, which is pumped through relief
valve.
HEADER EXPRESS DOWN
(Optional) – This dealer installed option is operated
from switch (G). To activate the express down
function, set switch (G) to "front down" position as
shown. In this mode, it is not necessary to hold
header height switch (F) to lower header fully. A
momentary touch and release of the "down" side of
switch (F) will fully retract header lift cylinders. To
stop express down function in mid-travel, touch and
release the "up" side of switch (F).
To bypass the express down function, set switch
(G) to "rear down" position. Header height switch
(F) will then operate as described at top of page.
REEL FORE-AFT CONTROLS (H) & (J)
(Optional) – For headers with hydraulic reel fore-
aft option. Press button at (H) to move reel
forward. Press button at (J) to move reel rearward.
HEADER TILT CONTROLS (K) & (L)
(Optional) – Press button at (K) to tilt header back
for a flatter guard angle. Press button at (L) to tilt
header forward for a steeper guard angle.
Form # 46584
OPERATOR'S STATION
and/or over-heating
E
F
REEL & HEADER HEIGHT SWITCHES
REEL FORE-AFT & HEADER TILT CONTROLS
HEADER EXPRESS DOWN SWITCH
24
H
K
J
L
G
Issue 11/06 Web Rev_01