MacDon 9250 Operator's Manual page 87

Electrical System
LIGHTS AND BULBS (continued)
CAUTION: To avoid a slip and fall injury
when replacing lamps at front of
machine, remove header and use a step
ladder, unless header has a traction
surface across the back tube.
REPLACING HEAD LIGHT BULBS
1. Turn light switch and ignition key to OFF.
2. Remove two screws from lamp bezel (A) and
remove light assembly from roof.
IMPORTANT: Do not remove the three
adjusting screws.
3. Turn old bulb to align tabs on bulb with cut-outs
in socket. Remove old bulb and detach wiring
harness connector
IMPORTANT: To prevent premature failure of
bulb, do not touch the glass surface with bare
hands.
4. Attach harness connector to new bulb (#9005)
and install bulb into socket.
5. Reinstall light and bezel, securing with two
screws.
IMPORTANT: For proper lighting pattern, be
sure lights are installed right side up.
6. Aiming of headlights should not be necessary.
REPLACING FIELD LIGHT BULBS
1. Turn light switch and ignition key to OFF.
2. Remove two screws from lamp bezel (A).
3. Release clip and remove bulb unit.
IMPORTANT: To prevent premature failure of
bulb, do not touch the glass surface with bare
hands.
4. Unplug connector (B) and connect new bulb.
Install and secure with clip.
5. Replace light and bezel, securing with two
screws.
IMPORTANT: For proper lighting pattern, be
sure lights are installed right side up.
Form # 46584
MAINTENANCE/SERVICE
85
A
REPLACING HEADLIGHT BULB
A
B
REPLACING FIELD LIGHT BULB
Issue 11/06 Web Rev_01